What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 29.06.2025 06:48
This is the picture of an electronic coil of wire wound around a core of magnetic material.
[old diagram got deleted by accident]
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
At one ohm, the resistor has a maximum of 1 watt power.
It also is a device that limits the change in current flow.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Your Ear Wax Might Hold Clues to Early Parkinson's, Study Finds - ScienceAlert
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
the problem then depends on "how fast does the fuse operate?".
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
The tiny Logitech Keys-To-Go 2 keyboard lets me get work done almost anywhere - CNN
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
but I think this circuit , shows a few more pieces.
How did you react when your doctor ordered a colonoscopy?
An AC voltage/ current source, and an ac inductive load.
One is “what exactly is in a ‘surge protector’ ? ”
(Dc diagram shown, AC is similar).
NASA to silence Voyager's social media accounts - theregister.com
a photo is worth a thousand words.
This is where the MOV conducts again, and dissipated the energy.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Raw recap & reactions: Royal chaos - Cageside Seats
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
How did China develop DeepSeek with less than 50 million USD when Trump is saying we need billions?
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
nine
Chevy’s C8 Corvette ZR1 Supercar Is Even Faster Than It Expected - Robb Report
He then asserts :
A fuse is a non-resetable over current circuit protector.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Est dolore nobis praesentium dicta voluptas aut.
what exactly is a ‘surge’ protector?
There are three different concepts here that are getting confused.
This is where this question deviates from being a 'generic' question, and becomes more specific.
What melts your heart every time without fail?
The MOV will conduct when the voltage exceeds 50% of line voltage.
This one hit behind the barn.
but this device (an Inductor) … impedes the rapid changes in the current.
For this case there are devices called Metal oxide varistors (MOV).
It seems Mohan does not understand the difference between a comment and an Answer.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
One
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
So, the voltage could go up to 500 volts, and the fuse will not open up.
This is 'the assistant's answer'
A circuit breaker is similar, but is resettable.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
2024–10–16 [ OO OLAOYE OYEBODE ]
Because the load is inductive, the current lags the voltage.(by a bit).
2024–10–14 [Omar Gharbi Omar Gharbi ]
But it can get overloaded, and no longer works.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
At least they know the answer if they wanted it.
He then describes the function of a fuse.
The third is lightning and “how it gets conducted into a home.”
Edit 2024–10.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
There are two important concepts here.
Now when you have a certain ac resistance, then a current flows in a loop.
2024–10–10[John johnson John Johnson ]
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
What is lightning?
But… the neutral is now “floating” because of the 1 ohm resistance.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
He then describes Rainy Season and Lightning.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
so, what happens?
Barnstars:
In schematic diagrams this is the symbol for a fuse:
I post the exact comment here.
The bolt then partially travels down the line to your home.
Upvotes:
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
eight
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
These are simplified answers to the original question, and does not change anything I wrote above.
What does a fuse do?
Here is a simplified AC power diagram.
The other is “what does a “fuse” do?”
[image of Common-mode choke]
First Sentence:
This device then solves the entire problem.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
These devices are installed between the “hot” and “neutral” and protective ground.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).